The wireless wall switch for up to 3 X10 receivers with dimming function. Wireless by RF - you can use it really everywhere!
X10 commands: On, Off, Dim, Bright
Did you always want to attach a light switch to a particular place but didn't want to drill any hole to the wall and to transfer new lines? This wireless slimline wall switch is then the right thing for you! This super smooth, super thin and lightweight RF wall switch adheres to every surface!
The SS13 works with every X10 wireless receiver like e. g. the TM13, CM15Pro or SC9000. You can switch on/off up to 3 different X10 modules and, if the corresponding X10 address is a lamp module, even regulate the brightness. The SS13 is prepared for house code "A" in the default mode (after inserting the battery). The three upper buttons control X10 modules with the Unit codes 1, 2 and 3. The lower button is for "Dim" and "Bright" X10 commands. Of course you can change the house and unit code, like described in the detailed operating instructions, according to your wishes or requirements of your X10 controller.
Technical information:
- Power supply: 1 x CR2032 3V lithium battery (included)
- RF range: up to 30m free area, up to 20m through walls and ceilings
- RF frequency: 433.92MHz
- RF power: 1mW
- X10 addresses: 3 (sequential)
- Ambient temperature: -10°C to 50°C (operation), -20°C to 70°C (storage)
- Dimensions: 115 x 70 x 7mm
- Certificates: CE
cheapShirt
ErikaJo CarService
SunClub P65
