AW12 In-Wall Appliance Module - X10 - Marmitek

You would like to keep your existing wall switch design but not do without the comfort of the home automation? This in-wall appliance module is then the right thing for you!

X10 commands: On, Off, All Lights On, All Lights Off, All Units Off

The AW12 is a very little X10 receiver for the installation behind (existing) switches and electrical outlets. For local control it can be connected to up to two switches or momentary switches. Thus a so called change-over switching can be realized. The AW12 is designed to fit in the rear of European junction boxes, behind any installed switch or outlet, presupposed a rest mounting depth of approx. 20mm.

Features:

• Very small - 46 x 46mm and only 17mm height.
• Up to 16A load.
• Quiet relay.
• House code, unit code and adjustments are very simply to programme with any compatible X10 controller (e. g. EasyControl 8 in connection with the TM13 transceiver).

Applications:

• On/off remote control for electrical devices.
• X10 control for already existing switches.
• Free choice (brand, design, colour etc.) for switches and electrical outlets.
• Invisible installation of X10 modules.
• Converts every existing electrical outlet to a X10 controlled electrical outlet.
• Ideal also for the installation into ceiling outlets, devices and everywhere else where space is too limited for bigger X10 modules.

Technical information:

• Power supply: 230VAC/50Hz
• Energy consumption: < 20mA capacitive
• Capacity: 600W/230VAC inductive/capacitive load, 3,600W/230VAC resistive load, 2,000W/230VAC low voltage halogen lights
• Minimum load: 3W
• Input impedance: > 180 Ohm (L-N) at 120kHz
• Signal sensitivity: 15mVpp min. 50mVpp max. at 120kHz
• External control: on/off switches, momentary switches
• Relay load: 16A
• Conductor size: up to 2.5mm²
• 3 phase operation: with 3 x FD10 Filter / Coupler for rail mount or 1 x CAT4000 Phase Coupler Repeater
• Ambient temperature: -10°C to 40°C (operation), -20°C to 70°C (storage)
• Dimensions: 46 x 46 x 17mm
• Mounting dimensions: 50 x 50 x 20mm
• Warning: For professional installation only! Please consult your electrician.
• Certificates: CE

Note: Please read our FAQs for use with luminescent lamps and energy-saving lamps!

Note: This product is also available as special offer!