Ocelot Home Automation Controller Set - X10 - Applied Digital

The intelligent control system for your home automation: Up to 1.024 different infrared commands - send and receive - and programme code produced automatically up to 4.096 lines. Central processing unit for all ADI products and real bidirectional X10 communication.

Features:

• Fully programmable, if-then-else control.
• Over 4,000 lines of programmable code.
• Infrared send and receive.
• 2 way X10.
• RS-485 expansion to a variety of low cost I/O modules.
• Comes with easy-to-use CMax Control Wizard Software.
• The perfect controller for use with HomeSeer!

Operation:
Connect the Ocelot with the enclosed cables with a free serial port of your PC as well as with the Powerline Interface XM10. Now connect the power supply (9 - 12V DC or AC, at least 1,000mA recommended, dependent on the number of connected ADI products, not included) and install the enclosed CMax software. You can now programme your Ocelot according to your wishes and needs and teach it the desired infrared commands with CMax. The CMax software is very easy to use so you will get satisfying results very fast even without English knowledge. After you have finished transmit your program into the internal memory of the Ocelot. You can now disconnect it of your PC.

Application:
The Ocelot has practically unlimited programming possibilities. For every X10 module time settings are programmable on day, weeks, periods or annual basis. Automatic setting to summer and wintertime. It calculates sunrise and sunset times by using your geographical position. Of course several settings per module are also possible. For lamp modules the light level can be preprogrammed in %. The CMax software uses logical "if-then" combinations, so that it executes further actions like a X10 command, an infrared command or a command for another ADI product when the desired condition applies. The conditions can be based also on infrared signals or data received by other ADI products besides the conditions mentioned before.
All settings are programmed in the non volatile memory (EEPROM) of the interface so that they are not lost at power failure either.

Technical information:

• Dimensions: L165 x W95 x H35mm
• Power supply: 9 - 12V AC oder DC, 200mA
• Firmware: 4,096 lines program code, 64 timers, 128 variables, 1,024 IR commands, real time clock
• Infrared receiver: integrated

Connections:

• I/O: RS232 - DBSF with 1.8m cable
• X10 (to XM10): RJ11 with 1.8m cable
• ADNET: 2 screw terminals
• Power supply: 2 screw terminals
• Infrared input: 3.5mm stereo jack
• Infrared output: 3.5mm stereo jack

System requirements:

• Powerline Interface XM10
• Power supply 12V DC or AC min. 200mA, dependent on the number of connected ADNET modules (not included)

Set contains:

• CMax software, CD-ROM
• RJ11 cable 1.8m
• RS232 cable 1.8m
• Powerline Interface XM10
• Manual

Note: This product is also available as SmartHomeSeer Ocelot Kit!